Remove the old deadbolt.
How to change your locks on door.
Remove the two visible bolts in the turn assembly plate and then remove the turn plate.
Remove the two screws from the latch plate on the edge of the door and remove the latch from the opening.
How to change a lock step 1.
Remove the old lock.
There are re keying kits that contain all.
Make sure the top of the deadbolt is facing up.
In some cases door latch plate mortises might need to be cut or enlarged.
Remove the screws from the old lock on the inside of the door.
After lining it up load in the deadbolt and fasten to the side of the door with two phillips screws.
Insert the pins and reassemble the lock dump out the old pins insert the new key and use tweezers or small needle nose pliers to match the new colored pins to.
Be careful not to over tighten.
Locate the screws on the interior side of.
How to change locks.
This allows you to pull the door knobs off the door from both sides.
Use a phillips head.
Go to the store and purchase a new lock.
A step by step guide step one.
Replacing a knob lock.
Insert your new deadbolt.
This part is pretty easy.
Begin by removing the screws from the door knob on the interior side of your door.
Orient and load in the new deadbolt lock into the side of the door.
Purchase a new lock.
Take your new deadbolt hardware and install it where the old one was.
Purchase a kit labelled for your lock s brand.
How to change door locks method 1 of 3.
Once the new pins are in reverse the steps to reassemble the lock.
Remove the old deadbolt lock and hardware.