How To Adjust Springs Garage Door

Next get hold of one of the tension rods and push it into the first notch.

How to adjust springs garage door.

Take note of the notches and screws that hold the torsion spring in place. This can make the other parts of the garage door last a much longer time. If the door was closing too quickly move the spring to the next higher hole on the bracket. Adjust the springs on both sides of the door the same way.

If it was opening too quickly move it to the next lower hole. One end of the spring is connected to the garage door track or frame. Adjust the spring into the proper position and make sure your garage door closes all of the way. Hold the garage door in this position by attaching a c clamp to the track at a point below the lowest door roller wheel.

The other is attached to a pulley connected to the cable. To adjust your garage door s side mounted springs first open your door fully and secure it in place with a c clamp below the bottom roller. The cone is on the torsion spring on the left side away from the. Retest the door.

Garage door springs are used to offset the weight of the door. How to adjust a torsion spring garage door step 1. This is accomplished by opening the garage door as fully as possible until it hits the stop bolt on the track. Without the springs the door is very difficult to lift.

Adjusting garage door springs is a common repair. Detach the old spring from both ends and replace it with the new one and replace the pulleys as well if they are worn out. It should be placed on the left hand side of the torsion spring and placed away from the garage door s center. Troubleshooting garage door springs.

The rod will need to be at least 18 inches long and 1 2. You must release the tension on the garage door springs before attempting adjustment or replacement. Once your garage door is secured remove the spring hook from the track hanger which will allow you to move the hook and adjust the spring s tension. How to safely adjust your garage door spring.

Use a metal rod to stick in the first notch of the cone. Once the spring is free of tension remove from its track hanger.