How To Attach Rope Lights To Garage Door

Don t use staples nails or a hot glue gun to hang your lights.

How to attach rope lights to garage door.

Many attach securely and safely to shingles or gutters. Wrap the strand along one side and across the top if long enough until it is taut. Push the wire through the cable connecter then screw the block to the sheathing. You can find various types at a hardware or home improvement store.

Start the first light strand at the bottom corner of either a window or door and work upward. Remove the cable s outer jacket and strip the insulation from. Rope lighting is unique. Insert the cable end far enough for the wires to reach the terminal board.

Basically what you need to do is attach the outlet feed wires to the back of the garage light switch to estabilish a passthrough circuit. Create a rock solid base for exterior light fixtures mounted on vinyl or aluminum lap siding without removing any siding. Place the tape directly on the center of the truss. It s a flexible solid plastic rod with a series of tiny bulbs embedded in it.

Rolls and cut it on the job. Grab a ladder and roll the tape along the bottom of the truss. Calculate the total length needed add 10 percent and buy one long piece it s available in 250 ft. I used a small roller to securely press the tape onto the truss.

Install a cable connector into a hole on the motor housing. This will allow the electricity from the circuit before the switch to pass directly through to the outlet for the garage door opener. This is one way to install christmas lights around a garage door with out damaging your home. Only roll out as much as you can reach so that the roll doesn t fall to the ground and get dirty.

Attach a power connector to one end of the rope lighting photo 9. To avoid damaging your lights and creating a fire hazard at the same time use clips or hooks to hang your lights from your garage.