How To Attach Cord To Garage Door Bottom

If your garage door cable is at an angle or l.

How to attach cord to garage door bottom.

Prepare the new cable by cutting off any pieces of tape wrapped around it. The cables wrap around the drums as the door opens and unwind from the drums when closing. Attach weather stripping to the bottom edge of garage door. Diy garage door repair and save money.

The cables attach at the bottom end to the bottom bracket that is mounted to the bottom of the bottom panel. Pull the cable as tight as possible before tightening the setscrews. Always be careful when using a sharp knife. Rotate the drum to wind the cable into the winding grooves.

Remove the cable from the bottom bracket and then completely remove the cable from the door. Snap a locking pliers onto the torsion tube to lock it into place while you tighten the drums. Install the roller into the bottom bracket and thread the cables behind the rollers on the door. This video will show you how to repair a mis aligned garage door cable.

Stand the bottom door panel on the floor in the garage doorway. Screw cable brackets to the door to secure the weather stripping. Fasten a new garage door bottom seal to a wood garage door. Clamp it into place.

Use impact driver to mount hinges to the bottom panel of garage door. Insert rollers into the brackets attached to the door. Push the track into wet caulk and tight against the door bottom. Leave the locking pliers in place and repeat the tightening procedure on the other side.