How To Attach Christmas Lights To A Masonry Wall

Masonry fasteners and anchors are permanently placed into concrete brick and stucco but are complete overkill for hanging christmas lights.

How to attach christmas lights to a masonry wall.

Slide the coated wire portion of the light strand through a hook in the clip to. Start at one end and apply hot glue along the side of the base of the light then press it firmly against the brick. If you prefer having the lights stick out from the wall instead place a dot of glue under the base of each socket. To remove the light simply shake the base a bit which will release it from the brick.

Lay out your string of lights to ensure you have enough length to work with. The bulbs will be perpendicular to the wall once you finish hanging them. You ll need yellow wall plugs a drill with 5mm masonry bit and a dustpan brush set the drill to the hammer setting. Spread a thin layer of glue on the wet part of the brick more is less in this case press and hold the.

To use a clip just snap it over the brick vertically in the location where you want it to hold the light string. Start at one end and apply hot glue along the side of the base of the light then press it firmly against the brick. Hold it for about 10 seconds which should be enough time for the glue to cool and the light to adhere to the brick surface. What adhesive will stick to brick.

Clean the bricks with a rag brush or broom to get all dirt and debris off the surface of the bricks wet a sponge and wipe across the surface of the brick. They can damage walls and interior surfaces plus. Stick a small adhesive decorating clip to the walls in each place you want to attach a strand of lights.