How To Attach Bathroom Sink To Wall

Install the sink if your sink includes a mounting plate you can use that for a template to drill your pilot holes.

How to attach bathroom sink to wall.

If not turn off the water at the main valve. The valves are typically under the sink. If the cabinet has no back simply attach it to the wall so it encloses the plumbing. Use plumber s putty as you attach the.

Verify the toggled wings open once you. Follow manufacturer s directions for the size and depth of. The standard cast iron brackets available for vintage sinks do not seem designed for this sink s brackets. Remove the current sink by sliding the edge of a putty knife around the perimeter of the bathroom sink loosening any caulk that connects it.

Use the template that comes with the sink to mark the. Smear pipe dope onto the threads of the supply line compression fittings and tighten them onto the faucet supply lines. Attach the vanity to the wall using 3 inch drywall screws. Measure and mark the location of the sink on the wall again.

Attach the sink 1. Check the level again before trimming the shims with a utility knife. This metal or plastic nut will be located either in the wall or the floor. If the cabinet has a back you ll need to measure and cut three holes for the two supply lines and the drain.

Loosen the slip nut at the top of the p trap. Lift the back edge of the sink onto the bracket. For sinks that do not attach with a bracket ask an assistant to hold the sink at the wall so the upper holes at the rear underside of the sink. Installing a bathroom sink in a vanity is made easier by the fact that the supply lines and the drain all remain hidden within a cabinet.

Lift the sink slightly while tightening the nuts with a wrench. Mount the sink to the wall. Remove the entire trap if necessary. Drill your pilot holes for the lag screws which should be included with your wall mount sink.

Set the sink on top of the pedestal then slide the sink close enough to the wall so you can insert the winged toggles into the mounting holes in the wall. Locate the large nut that connects the sink to the drain and disconnect it. Two on the rear against the wall and one on each side. Drill pilot holes into the wall at the marked locations.

Then turn on the faucet. Slip the sink over the mounting bolts and finger tighten the mounting nuts over the washers. If there are large gaps at the wall or floor attach quarter round moulding along the wall or floor edge. Prepare the faucet drain and pop up.

Turn off the water supply. The pockets are not deep enough for the tabs on my sink the holes do not align etc. Be sure to use a masonry. Ideally i would like to mount the sink using only the two rear tabs bolted to the wall.