Failure to install the torsion springs on the correct side will cause your door to function improperly and could result in serious injury.
How to adjust side springs on overhead garage door.
Side mounted springs are long heavy springs mounted on each side of the upper garage door track.
If it was opening too quickly move it to the next lower hole.
Once your garage door is secured remove the spring hook from the track hanger which will allow you to move the hook and adjust the spring s tension.
Black winding cone torsion springs are used on the right side of the door and red winding cone torsion springs are used on the left side of the door when viewing the door from the inside looking out.
There are two torsion springs at each side of the garage door.
Extension springs stretch along the top track on each side.
For extension springs this is in the up position.
Release the tension on the springs by opening your garage door all the way and securing it in place with a c clamp.
This tension makes it easier to lift the garage door from its closed position.
This video applies t.
The springs extend along the shaft and work by twisting as the garage door closes by means of cables attached to each side of the lowest garage door panel.
Then disconnect any existing safety cables and remove them away from the door springs.
Adjustments to these types of spring should only be done by a professional.
The springs are located at the top inside part of the garage door.
A garage door that is not attached to the springs can fall and cause injury.
These types of springs can be adjusted by the.
Tips for adjusting side mounted springs.
Retest the door balance as you did in step 1.
The torsion spring helps the garage door open and close easily.
Torsion springs are mounted directly above the door and need to be wound with special tools.
See below to make sure the door is secured before you work on it.
To be able to adjust the springs the door must be in a position that release the tension on the springs.
To adjust your garage door s side mounted springs first open your door fully and secure it in place with a c clamp below the bottom roller.
Once the spring is free of tension remove from its track hanger.
There are two different types of spring systems for garage doors.
Adjust the springs on both sides of the door the same way.