The other situation would be if door is not closing level.
How to adjust garage door not closing evenly.
These may be on the side of the box but are usually at the rear.
Hold the garage door.
How to adjust a garage door to close completely.
Once the spring is free of tension remove from its track hanger.
After adjusting your spring unclamp the door and lower it to test the spring.
The extension springs are evenly matched and installed to keep the garage door properly aligned so that it runs smoothly throughout the entire length of the track and closes evenly.
Garage door spring adjustment information.
For more advice like how to adjust your garage door s torsion springs read on.
Side mounted extension springs are installed above the horizontal roller tracks on both sides of the door.
Check that it is straight.
Push the door push the door back to adjust the door and get the center aligned again.
If the door was closing too quickly move the spring to the next higher hole on the bracket.
If it is still not closing correctly secure the door again and keep adjusting the spring until your door fully closes.
If one side of the door is not in line with the other the door won t run smoothly in its tracks and when closed one side of the door won t close completely leaving an open gap.
When this happens adjusting is in order.
Adjust the springs on both sides of the door the same way.
To adjust a door in this instance i either use better longer wood screws and try to fix deeper through the frame into the timber stud behind that the frame is fixed to.
This is accomplished by opening the garage door as fully as possible until it hits the stop bolt on the track.
Alternatively plug the screw holes with a rawl plug or lots of matchsticks.
Identify the switches by the up or open.
Have a helper steady the ladder.
If it was opening too quickly move it to the next lower hole.
An adjustment could solve this problem.
To decrease tension move the hook to a higher hole.
Read on to find out if adjusting garage door springs is something you want to tackle.
It could be that one spring is putting more force on the door than the other.
Retest the door.
Look for two limit adjustment screws.
Place a stepladder beneath the box portion of the garage door opener.
How to adjust a garage door that is uneven step 1.
