How To Add A Pull Switch To A Wall Light

Place the cover plate over the switch and secure it with the holding screws.

How to add a pull switch to a wall light.

Unscrew the two screws that hold the switch in the box and pull the switch and the wiring out of the box as far as the wiring will allow. I have bought some wall lights that dont have a internal pull cord on them as the lights are currently wired from the ceiling rose with a live feed coming in. Determine where the pull switch will fit inside the socket and drill a hole large enough for the nut attachment of the switch to fit through. Place the light switch inside the wall box and tighten the mounting screws with a phillips screwdriver.

Take note of which wire causes the tester to light up. With the light switch turned off hold the noncontact voltage detector against each of the wires connected to the switch. When you tighten the screw it will pull the wire down. What i want to do is i have bought a mini pull switch 2a from tlc and drill a small hole to fix it to the light fitting base i.

First make sure the toggle switch fits between the plate and wall. Pass the chain through the hole and tighten the switch to the socket with the nut provided. Insert a new section of electrical cable of the same. Prep for installing toggle switch.

Restore power and operate the light with the new switch. To wire the ceiling fixture to the new wall switch first connect the copper grounding wire to the fixture. Tighten those screws with a slotted screwdriver. This is the hot wire and the one you ll connect to the hot side of the new double switch.

Using a drill press make the hole for the switch in each plate. To attach a wire to a screw bend the bare wire to the left and slip it over the screw. If you are adding a switch to a finished wall see fish wires through walls for directions. After removing the black wire to the fixture s lead splice it into the new white wire.

Mark this wire black.