Once triggered the lever or lock trim can be removed from the door.
How do you take a doorknob off locked door closet.
Using a philips head screwdriver turn counterclockwise to unscrew a knob with standard hex head screws.
Don t worry removing a door from its hinges is an easy task that can be done in under a minute.
This causes the doorknob to separate inside and both sides can be removed from the door.
In this situation you will need to locate the latch on the side of the knob.
Use a phillips screwdriver to remove the screws that run from one backing plate to its opposite through the bore hole.
Best of all it only requires a hammer and a small screwdriver.
These screws hold the entire knob and latch assembly together.
Look for a thin slot or a recessed hex head setscrew on the lock side of the doorknob.
Unscrew your door knob begin by holding the door knob securely in place.
Look closely at the shank of the interior doorknob and you ll see a tiny slot or hole.
If the knob has a recessed setscrew turn the setscrew counterclockwise with a correctly sized.
To simply remove the door knob itself there are much fewer steps.
Tug on the knob and it will slide right off.
Then pry off the round decorative plate called the rose to expose the screws that hold the lockset onto the door.
Push the tip of a narrow blade screwdriver or nailset into the hole.
This is typically located on the side or base.
Apply a bit of pressure to the paper clip to trigger a release button inside the hardware.
Many door knobs have trim plates that cover the screws so removing them can be a bit tricky if you ve never done it before.
Pull the spindle from the center of the latch if applicable.
Use the screwdriver to push the opposite side of the doorknob from the door and latch.
So the only way to get a door open when you re on the outside and it s locked from the inside is to remove the door from its hinges.
Thread the screwdriver through the large spindle.
Straighten a paper clip and insert it into the hole.
Use a drill driver to remove the longer mounting screws.
If your knob has a pinhole or small slot opening use a flathead screwdriver to push it inward.
