How Do You Lay Roll Roofing

The canvas is rolled up into a roll back to the point of attachment.

How do you lay roll roofing.

To install roll roofing you ll need to cut the material into long strips of the correct length for your roof and lay it flat. A gas burner is held so that it warms up the ground surface and the lower surface of the material. The strips should always be horizontal. Step 3 apply the edge strips.

If possible install roll roofing over a smooth plywood deck either perpendicular or parallel to the slope. You need to place starter strips of roll roofing along all edges of the roof so start by cutting pieces of roofing about 18 inches wide. The roofing should overhang the eaves by inch except where you install drip edge flashing on top of the roofing along the rake edge. To seal a plumbing vent spread roofing.

How to properly install roll roofing. Roll roofing is not very pliant or flexible in cold weather of fewer than 45 degrees fahrenheit and it can crack and break if. For this heat up the gas burner and push it to the edge of the site where it will be fixed. An underlayment of felt roofing is optional.

Plan so that no two butt joints are closer than 2 feet from each other. Be careful not to get any on your skin in this process. It also helps if you first install a layer of roofing felt. Position the first course so it overhangs the drip edges by about 1 4 inch and roll it out a.

Fix edge fabric roll.