You can paint both sides of the hardware within seconds and save a ton of time.
How do re polish your front door handles.
Pay special attention to the disinfectants ingredients.
Create a paste from equal parts of flour vinegar and salt.
Scrub everything clean and then wipe it down with a dry towel.
And my kids loved it because i let them watch a show while i did it which they rarely get to do.
Leave it for a couple of minutes and then wash it off with hot soapy water.
Once you have removed excess dirt and grime from your hardware you re ready to disinfect it.
Once you re done apply a clear coat spray to the handle and parts to keep it sealed and protected.
First off there are many different ways oil rubbed bronze can be achieved which is why it s difficult to match.
Your brass or copper handles are restored.
Scour the doorknob to remove the surface layer of built up grime corrosion and tarnish.
About a tablespoon apiece is a good place to begin depending on how much hardware you plan to clean.
How to paint exterior door handle.
Disinfect your door hardware.
Be sure to refer to the product s manual for more information.
Then rub it onto the surface of the metal and wipe it clean with a cotton cloth.
This works for your cookware too.
Sometimes simple wear and tear can make your door handle feel loose.
Some contain harsh or abrasive chemicals that will damage the finish of your hardware.
Then rinse it and buff it with a soft cloth.
I think it took me a couple hours at most.
Okay so here it is.
It really is not a bad process at all.
This makes the painting process seamless and easy.
1 place your hardware in a disposable metal container.
Gently rub the paste onto your solid brass and copper door hardware pro tip.
If possible avoid overlapping them.
2 add a good dollop of dish soap and fill with water.
Front door hardware not so much.
Alternatively take a cut lemon and dip it in salt.
Tighten up your front door handle.
The best way to get the paint off is with a slow cooker.
Guys if you have thought about doing this go for it.
Use a lacquer thinner or a mixture of vinegar and salt scour with 0000 steel wool the finest available on solid brass but very carefully on plated surfaces.
An old soft t shirt is a better choice for thin brass plated surfaces.