Put your tape measure on the floor in front of your door and measure up 41 inches from the floor since this is the most common placement for door handles.
How do i install a door handle.
With utility knife mark new spot for strike plate and trim.
This is the exterior portion of your hardware with the spindle extending from the back.
Screw the screws into the holes.
If your new handle matches the hole configuration of the old one the entire job should be done in just a few minutes with nothing but a screwdriver or two.
Move the wedge as you change the side of the door you re working on.
It must line up with the holes in the latch assembly to function.
Before you start installing the door handle place a door wedge under the door to stop it from moving while you re working.
How to install or replace a storm or screen door handle easy to do yourself.
Remove the old door knob latch and strike plate.
The spring operated bolt with a beveled face to permit a latching action when the door closes.
Put the new lever assembly in place.
Installing a door handle is a relatively easy diy project.
Installing a door handle is a relatively easy home project that you can do with a pre made kit.
Previous step next step.
Watch this step by step video guide from bunnings warehouse and learn how to make sure the handles.
Drill into the receiver hole.
Gently close the door checking if latch hits the strike plate in the same place.
Mark where the door handle will go.
With the latch assembly in place slide the door handle with the attached cylinder into place.
Install the latch determine whether you want to use a flat rectangular faceplate or a round drive in faceplate.
Follow our instructions for installing a front door handle and lockset to get a fresh look you love and enhance your home s curb appeal.
Storm door handles are easy to install or replace yourself.
If you re in a situation where you cannot or do not want to use a drill to install your lock there are a couple ways of installing an interior door lock without a drill.
This is the interior portion of your knob or lever for privacy knobs and levers you ll want to be sure the push button lock is on the inside.
If you have not already removed the old door knob and latch take it out before you begin installing the new one.
The strike plate is a rectangular metal piece that.
Step 4 install lever assembly.
If not take off strike plate.
Drill new openings and install.
