The springs extend along the shaft and work by twisting as the garage door closes by means of cables attached to each side of the lowest garage door panel.
How do i fix my garage door spring.
In order to replace your garage door spring s you will need to find the current measurements in order to accurately replace the spring s.
If the door remains in place the replacement was a.
However when you need to get your car out of the garage it may be necessary if you cannot wait for the repairman.
This is when injuries occur.
Loosen the set screws while holding each spring with a winding bar.
Unplug the garage door opener and clamp the door to the track.
When you are using a winding bar to tighten the spring the bar may slip out and cause a sudden release of the spring s tension.
Use extreme care when opening a garage door in this manner.
A garage door should not be opened until the spring is repaired.
Leaving the garage door open and securing it ensures that the tension on the spring is released.
Disconnect the garage door opener so the door remains.
Once the tension is released you can remove the spring from the track.
After you then disconnect the safety cable from one end.
This tension makes it easier to lift the garage door from its closed position.
This should take about 3 minutes and you don t need to remove the springs or loosen the tension to measure them.
Removing the old springs 1.
Position a sturdy ladder to the side of the.
Replacing garage door springs is not a do it yourself project replacement requires special tools and techniques to prevent injury.
First do not try to lift the door by hand or using the opener as you can hurt yourself lifting a heavy garage door by hand and burn out the opener using it to try to open a door with a broken spring.
Clamp a locking pliers or a c clamp to the track just above one of the rollers.
The size of the door and the type of spring system determines how difficult opening the door will be.
Shove a winding bar into a bottom hole of the winding cone of the good spring.
Side mounted springs are long heavy springs mounted on each side of the upper garage door track.
Unwind each spring with the.
Secure the door open preferably using c clamps.
Lubricate the spring with garage door lubricant then remove the clamp from the garage door.
Loosen the unbroken spring.