Honda Door Lock Actuator Screws Stuck

Observe the plastic tab above and beneath this screw.

Honda door lock actuator screws stuck.

There is many helpful tips and tricks to aid you in. Average repair cost is 610 at 84 500 miles. Unclip and remove the inside door handle rod can t remember if i did this before or after unscrewing the locking mechanism. In some cars the door lock actuator is positioned below the latch.

Make sure the open link tab fits into the open link slot. A rod connects the actuator to the latch and another rod connects the latch to the knob that sticks up out of the top of the door. Remove this screw and unhook the tabs holding the black plastic housing for the actuator. The 2010 honda cr v has 4 problems reported for door lock actuators failed.

Take the inside door release lever panel off and push the lever rod all the way to the rear. The lock actuator is behind this screw. Remove the single screw in the middle of the gold plate taking care to note the position orientation of the small locking lever. Car door lock actuators are designed to lock and unlock a door without the effort of pulling on a cable and rod.

Unclip the broken actuator from the locking assembly. 2007 honda cr v door lock actuator repair. The latch assembly gets corroded and when the pull lever cannot return fully to the rest position the latch assembly will not operate. Install the lock subassembly onto the new door lock actuator using the new screws from the kit p n 72116 swa a01 and p n 72116 swa 003.